在裝配不同復合材料結構時，就會進行二次接著，如法蘭或人孔等與主體結構的搭接，此時應該首先對已固化的樹脂表面進行良好的表面處理，要求露出玻璃纖維表面；同時在接著時，應該用表面氈或短切氈開始和結束鋪層，而不能用纖維布，因?yàn)榻又戤叺慕Y(jié)構雖作為一個整體，但結構失效最大的可能是接著層分層，若采用纖維布就會極大的增加這個可能性。(To ensure a successful secondary bonding, the composite with a fully cured surface must be prepared by grinding the laminate down to exposed glass prior to applying a new laminate. And finish a primary laminate with chopped fibres/chopped strand mat or spray roving, and always start with chopped fibres for the secondary laminate. If a woven roving ends the primary laminate, or starts the secondary laminate, the dangers of delamination failures are great.)